1. Please take a little time for this simple survey! Thank you for participating!
    Dismiss Notice
  2. Dear Pleskians, please read this carefully! New attachments and other rules Thank you!
    Dismiss Notice
  3. Dear Pleskians, I really hope that you will share your opinion in this Special topic for chatter about Plesk in the Clouds. Thank you!
    Dismiss Notice

Executing command upon receiving email

Discussion in 'Plesk for Linux - 8.x and Older' started by hakkrdan, Jan 5, 2005.

  1. hakkrdan

    hakkrdan Guest

    Hello, all -

    I'm trying to make an application in which qmail receives a message, and executes a command via pipe.

    Not being familiar with qmail at all (mostly sendmail and Postfix), I do not know where to begin. On top of that, I am deathly afraid of messing with anything too much, because if I do, Plesk will surely freak out.

    So what I am asking is, how might I establish a setup for a single email address that executes said command upon recieving mail? I am not entirely familiar with the qmail setup wth Plesk, so I am not even going to attempt this just yet.

    Any help would be appreciated.