1. Please take a little time for this simple survey! Thank you for participating!
    Dismiss Notice
  2. Dear Pleskians, please read this carefully! New attachments and other rules Thank you!
    Dismiss Notice
  3. Dear Pleskians, I really hope that you will share your opinion in this Special topic for chatter about Plesk in the Clouds. Thank you!
    Dismiss Notice

FreeBSD Perl Problem plz help!

Discussion in 'Plesk for Linux - 8.x and Older' started by geeza@, Sep 2, 2005.

  1. geeza@

    geeza@ Basic Pleskian

    24
    23%
    Joined:
    Sep 1, 2005
    Messages:
    77
    Likes Received:
    0
    Hi Guys,
    I've recently installed Plesk 7.5.4 on FreeBSD 5.3. Everything is fine apart from apache which is refusing to start. The reason it gives for this is as follows.


    Syntax error on line 303 of /usr/local/psa/apache/conf/httpd.conf:
    Cannot load /usr/local/psa/apache/libexec/mod_perl.so into server: Shared object "libperl.so" not found, required by "mod_perl.so"


    I installed Perl5.8.7 from src and everything seemed fine, however there is no libperl.so on my system (I searched the entire disk).

    I think I need to remove/reinstall perl. Is this safe to do or will doing this ruin my current Plesk installation?

    This is the output I get from perl -v :

    This is perl, v5.8.7 built for i386-freebsd

    Copyright 1987-2005, Larry Wall

    Perl may be copied only under the terms of either the Artistic License or the
    GNU General Public License, which may be found in the Perl 5 source kit.

    Complete documentation for Perl, including FAQ lists, should be found on
    this system using `man perl' or `perldoc perl'. If you have access to the
    Internet, point your browser at http://www.perl.org/, the Perl Home Page.



    Any help will be greatly appreciated :)
     
  2. geeza@

    geeza@ Basic Pleskian

    24
    23%
    Joined:
    Sep 1, 2005
    Messages:
    77
    Likes Received:
    0
    fixed it :). I installed the perl 5.8.7 port and it must have added the missing files.
     
  3. rx78gp03

    rx78gp03 Guest

    0
     
    I have the same problem, but even if I installed the new version of perl, it still doesn't fix the problem, could anyone help?
     
  4. etan

    etan Guest

    0
     
    use ports
    not the downloaded source code.
     
  5. alexr13

    alexr13 Guest

    0
     
    I've made the link from /usr/local/psa/lib/perl5/5.8.7 to /usr/local/lib/perl5/5.8.7 and Apache was started.
     
  6. etan

    etan Guest

    0
     
    you shouldnt have to do that :confused:
     
Loading...