1. Please take a little time for this simple survey! Thank you for participating!
    Dismiss Notice
  2. Dear Pleskians, please read this carefully! New attachments and other rules Thank you!
    Dismiss Notice
  3. Dear Pleskians, I really hope that you will share your opinion in this Special topic for chatter about Plesk in the Clouds. Thank you!
    Dismiss Notice

Setup VPN Module Problem - What IP's can I use for Local and Remove Peer addresses?

Discussion in 'Plesk 9.x for Linux Issues, Fixes, How-To' started by tower14sm@mac.c, Dec 7, 2011.

  1. tower14sm@mac.c

    tower14sm@mac.c Guest

    0
     
    Hello All,

    I just installed VPN Module on Plesk 9 in Linux. I'm trying to create a vpn tunnel for a server to server connection to share data. I have two IP's for the Local and Remote Peer address;
    xxx.xxx.xx.124
    xxx.xxx.xx.125

    But the system is giving me this error;
    Error: The two IP addresses must differ only in the two least significant bits, these being 01 in one address and 10 in the other. It is recommended that you pick .1 and .2 for the last octets of these addresses.

    If I understand this correctly I need to use;
    xxx.xxx.xx.1
    xxx.xxx.xx.2

    No ip's from my provider ending in .1 or .2 are available.

    Any advice on how to get this setup?
     
  2. tower14sm@mac.c

    tower14sm@mac.c Guest

    0
     
    Local and Remote Peer address

    Anyone? Thx.
     
Loading...