Resolved Plesk autoinstall error

[Damo]

Hello. I'm installing plesk on "CentOS Linux release 7.2.1511 (Core) 3.14.32-xxxx-grs-ipv6-64" though I'm receiving this error when I come to the end of the installation.

I've tried installing a few times using a clean install of CentOS. Can't figure out what's causing this issue.

Congratulations!
All stages of the installation/upgrade have been finished.
psa is now running on your system.
To complete the system configuration process, please proceed to URL:
https://removed:8443/ or
https://removed8443/
Use 'root' and '<YOUR root PASSWORD>' as login name and password in case of fresh installation.
Use 'admin' and '<YOUR admin PASSWORD>' as login name and password in ca se of upgrade,
or if Plesk is already configured.

Further, use the following commands to start and stop the system:
/etc/init.d/psa start and
/etc/init.d/psa stop respectively.


ERROR: The executed process was terminated because of unhandled signal received from the system.

Please try installing packages again later.
Please resolve this issue and try installing the packages again.
If you cannot resolve the issue on your own, contact product technical support f or assistance.

 

[Sergio Manzi]

Have you tried doing what it suggests, i.e. using your browser to go at the suggested address (https://yourhost.example.com:8443), where of course you must substitute "yourhost.example.com" with your real host name?

 

[IgorG]

You may check these two articles:

https://kb.plesk.com/en/129337
https://kb.plesk.com/en/129380

 

[Damo]

You may check these two articles:

https://kb.plesk.com/en/129337
https://kb.plesk.com/en/129380

Fixed