1. Please take a little time for this simple survey! Thank you for participating!
    Dismiss Notice
  2. Dear Pleskians, please read this carefully! New attachments and other rules Thank you!
    Dismiss Notice
  3. Dear Pleskians, I really hope that you will share your opinion in this Special topic for chatter about Plesk in the Clouds. Thank you!
    Dismiss Notice

PSA is running but cannot access web control panel

Discussion in 'Plesk for Linux - 8.x and Older' started by abyrne060275, Aug 11, 2005.

  1. abyrne060275

    abyrne060275 Guest

    I cannot access plesk from the web. I go to my site www.xxxxxxx.com:8443 and it redirects me correctly and shows the certificate warning like it usually does however the page never loads. I've tried restarting the system, manually stopping then starting psa but I'm at a loss here.

    It was working up until I added a cron job and rebooted, I'm not sure if that had anything to do with it.

    The sites are all up and running correctly I just cannot access plesk.

    Any suggestions, thoughts, or insights would be greatly appreciated.

  2. hardweb

    hardweb Guest

    I suggest you to check:
  3. abyrne060275

    abyrne060275 Guest

    Ahh, you are a genius, or I am a complete newbie, probably both! I forgot that I had modified the php.ini file plesk uses, whatever I did messed it up but I had backed it up before hand. Thanks for the error log info, without it I wouldn't have had a clue.

    Thanks again!