Resolved Migrating from cpanel to plesk Error Failed to connect

[Piero Meloni]

Hello, I have to migrate from an old server whm cpanel to plesk again, both are the latest updated versions, using the tools of plesk for migration but on cpnal (with root credentials) is released this
Error: Failed to perform action: Fetch data from source cPanel
Cause: Failed to connect to the the source server 'cpanel' (149.202.95.50) at '149.202.95.50' by SSH as 'root': Incompatible ssh server (no acceptable macs)
That is a critical error, migration was stopped.

I checked the ssh configuration whm and is nancy, I log in the traditional way via ssh, but with the plesk no tools.

This error is released although change always cpnale server with an installed ...

Suggestions? Thank you all.

 

[UFHH01]

Hi Piero Meloni,

does this KB - article help you to solve your issue?

Failed to connect to the source server by SSH: Incompatible ssh server (no acceptable macs) ( KB - article 127467 )​

 

[Piero Meloni]

Hello, thanks for your reply, I will insert the command lines to the new server where there is plesk but was released this

$ OpenBSD: sshd_config, v 1.90 5/16/2013 4:09:14 dtucker Exp $

# This is the sshd system-wide configuration file server. See
# Sshd_config (5) for more information.

# This sshd was compiled with PATH = / usr / local / bin: / usr / bin

# The strategy used for options in the default sshd_config shipped with
# OpenSSH is to specify options With Their default value where
# Possible, but leave them commented. Uncommented options override the
# Default value.
Cs HMAC-sha1, HMAC-MD5, HMAC-SHA1-96, HMAC-MD5-96
# If you want to change the port on a SELinux system, you have to tell
# SELinux about this change.
# Semanage port -a -t -p tcp ssh_port_t #PORTNUMBER
#
#Port 22
#AddressFamily any
#ListenAddress 0.0.0.0
#ListenAddress ::

# The default requires explicit activation of protocol 1
#Protocol 2

- INSERT -

and restarting ssh or the server is not received the command, definitely something wrong. Thank you

 

[Piero Meloni]

Solved, the configurations are made in the source server. Thanks so much for your invaluable help. Good job everyone.