H
henry@
Guest
ok just did. thanks S
is the release date still the 20th or later?
I have a new Windows server that I installed Beta 2 on yesterday. Following the install reboot the control panel did not start so i was unable to access the admin.
I manually started the control panel but access to the admin said 'service unavailable'.
Then the control panel turned itself off. If I turn it on and do nothing it will run for a couple of minutes then turn itself off again.
I have never installed Plesk before.
QoS was installed prior to install.
FTP was not
Here is what was loaded on the server prior to install;
Window Server Standard 2003, SP2
ColdFusion 8
ISAPI Rewrite 3
Any idea what went wrong and how I could get a correct install.
Thanks!
O.k. I fixed the persmissions for ISAPI Rewrite per your instructions.
Still have the same problem.
When I try to access Plesk Admin I get a 'service unavailable' page. Then the control panel shuts down.
When I turn the control panel back on, it stay on for a little over a minute, then shuts off again.
Should I uninstall Beta 2 or will I be able to install the 8.3 release over it as if I were upgrading?